HP Kayak XU04 Supplementary Manual page 45

Clearing the
PC Workstation's
Configuration Memory
Press to see more details about the message. After viewing
•
these details, you will be returned to the original POST display
screen. If the message is actually a change to the configuration you
have made (for example, you have just removed some memory), you
can then press
configuration information. Otherwise, press
message and continue, or press
system configuration error. (The number of choices you will have
available are dependent on the kind of error.)
If the PC Workstation then starts, but POST still persists in reporting an
error, clear the current configuration memory values and reinstall the
built-in default values:
1 Turn off the PC Workstation, disconnect the power cord, and remove
the cover. Disconnect the PC Workstation from any
telecommunications network.
a Set the system board switch 6 (CLEAR CMOS) ON to clear the
configuration.
b Replace the cover, and reconnect only the power cable.
c Turn on the PC Workstation. This will erase the CMOS memory.
d Wait until the PC Workstation has started. A message will be
displayed similar to this:
"Configuration has been cleared, set switch Clear
CMOS to the open position before rebooting."
e Turn off the PC Workstation, disconnect the power cord, and
remove the cover.
f Set the system board switch 6 (CLEAR CMOS) UP to retain the
configuration.
2 Replace the cover, and reconnect the power cord.
3 Switch on the PC Workstation. An error message will be displayed
similar to the following:
On your monitor:
Incorrect PC Configuration
The PC Workstation will stop. Press
errors) and then press
2 Troubleshooting Your HP PC Workstation
If Your PC Workstation Does Not Start Properly
to accept the change and update Setup's
to run Setup and correct a
.
to ignore the
On your PC Workstation's LCD:
Error! POST 0012
(to view the system
English 37