Computer Setup-Boot; Computer Setup-Exit - HP Elite 7000 Microtower Setup Manual

Table 3 Computer Setup—Power (continued)
Hyper-Threading
XD (Execute Disable)
Virtualization
Technology
Computer Setup—Boot
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 4 Computer Setup—Boot
Option
Boot-time Diagnostic
Screen
Boot Device Priority
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
Floppy Group Boot
Priority
CD-ROM Group Boot
Priority
Hard Drive Group Boot
Priority
Network Group Boot
Priority
Computer Setup—Exit
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 5 Computer Setup—Exit
Option
Exit Saving Changes
Exit Discarding
Changes
Load Setup Defaults
Discard Changes
Save Changes
4 Computer Setup (F10) Utility
Allows you to enable/disable hyperthreading.
Disables/enables XD bit.
Allows you to enable/disable Virtualization Technology.
Description
Disables/enables POST diagnostic messages display.
Allows you to specify which device groups will boot first, second, third, and fourth or to disable any
of the four:
●
Floppy Group
●
CD-ROM Group
● Hard Drive Group
●
Network Boot Group
NOTE: MS-DOS drive lettering assignments may not apply after a non-MS-DOS operating system
has started.
Specifies boot device priority within removable devices.
NOTE: This computer does not support floppy drives.
Specifies boot device priority within CD/DVD drives.
Specifies boot device priority within hard drives.
Specifies boot device priority within bootable network devices.
Description
Press Enter to exit saving changes.
Press Enter to exit discarding changes.
Press Enter to load setup defaults.
Press Enter to discard changes.
Press Enter to save changes.
ENWW