Installing A Pci Or An Isa Expansion Board - HP Compaq SP700 Reference Manual

9-4 Expansion Boards
Installing a PCI or an ISA
Expansion Board
To install a PCI or ISA expansion board:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the side access panel.
3. Remove the expansion board assembly from the workstation chassis.
4. Refer to the following illustration to remove an expansion slot cover.
Figure 9-2. Removing the screw and expansion slot cover
To replace an expansion slot cover, reverse the above procedure.