Canon imagePROGRAF iPF825 Basic Guide No.2 Basic Manual page 37

Error Message
This paper cannot be used.
Cannot print as specified. Lift
the release lever and replace
paper with A4/LTR (vertical) or
larger.
Cannot print as specified. Lift
the release lever and replace roll
with 10 in. wide or larger roll.
Hardware error. xxxxxxxx-xxxx
(x represents a letter or number)
Hard disk error.
Cause
Paper that is too large for the
printer has been loaded.
Paper that is too small for the
printer has been loaded.
Paper has been loaded that is too
small to print the test pattern for
printhead adjustment or nozzle
checking.
The loaded paper is too small.
The loaded paper is too small.
The last portion of roll paper was
used during a print job. The paper
was not advanced because the
trailing edge is taped to the roll.
Fastening tape or the Belt Stopper
has not been removed inside the
Top Cover .
An error requiring service may
have occurred.
The format of the printer's hard
disk is invalid.
37
Corrective Action
Lift the Release Lever and load paper of the correct
size.
(→"Paper Sizes," User Manual)
Lift the Release Lever and load paper of the correct
size.
(→"Paper Sizes," User Manual)
Lift the Release Lever and load unused paper A4
or larger. More than one sheet may be required
depending on the adjustment.
Switch to paper A4/Letter (vertical) or larger.
Load a roll 10 inches wide or larger.
Turn off the printer and remove the roll from the printer
before restoring power.
Turn off the printer, open the Top Cover and remove
the tape or the Belt Stopper before restoring power.
Turn off the printer and wait at least three seconds
before restoring the power.
If the message is displayed again, write down the
error code and message, turn off the printer, and
contact your Canon dealer for assistance.
Press the OK button to start reformatting the
hard disk. When formatting is finished, the printer
automatically restarts. (Formatting will erase all data
on the hard disk.)
Error Messages