Kia Sorento 4wd 2011 Workshop Manual page 2942

GROUP BODY
NUMBER 058
MODEL 2011MY SORENTO [PXM]
DATE APRIL 2010
SUBJECT: SERVICE ACTION: SORENTO (XM) EXTERIOR BULB REPLACEMENT (SA 031)
This bulletin provides information relating to Sorento (XM) vehicles built from October 23, 2009 to
February 12, 2010 that may experience reduced life for some of the exterior bulbs. Even though a
customer's initial concern is only in regards to a single bulb, Kia recommends replacing all eight (8)
bulbs simultaneously per instructions in this Bulletin.
The following instructions explain a simpler replacement procedure than currently listed in the
Sorento (XM) shop manual to replace Front Park/Turn Signal Bulbs, Rear Combination Bulbs, and
Redundant Bulbs located in the deck lid.
Front Headlamp bulb replacement does not require any component removal. Rear bulb
replacement is achieved by removing Rear Combination assemblies. Bulbs in Redundant lighting
assemblies can be changed via the access panels in the deck lid as shown in the photo below on
the right.
The photo above on the left shows the back view of the front headlamp assembly. Do not remove
the front headlamp assembly to change the turn signal bulb. If necessary use a suitable tool to
firmly push the pink bulb cover tab (arrow) while using other hand to assist in rotating the cover
counterclockwise to open.
NOTICE
Ensure that the dual filament bulbs are installed properly. The dual contacts must line-up correctly
in the socket for proper bulb operation.
After replacing the bulbs; reinstall components. Verify that all new bulbs are functioning properly.
Ensure that the dual filament bulbs are installed properly.
NOTICE
A ServiceAction is a repair program without customer notification that is performed during the
warranty period. Any dealer requested perform thio`is repair outside the warranty period will require
DPSM approval.
Repair status for a VIN is provided on WebDCS (Service>Warranty Coverage> Warranty Coverage
Inquiry>Campaign Information). Not Completed Recall/Service Action reports are available on
WebDCS (Consumer Affairs>Not Completed recall Action reports are available on WebDCS
(Consumer Affairs>Not Completed Recall Recall VIN>Select Report).
The issue number is SA 031.
AFFECTED PRODUCTION RANGE