Table of Contents
Advertisement
2. Use a clean work area with protective covering to prevent soiling or marking of the trim pieces of
customer's seat.
Release seat track lever to push seat track rear-ward for ease of access to the working area.
Tracks must be reset prior to the seat install.
3. Align the U-bracket over the torsion tube as shown Front edge of bracket should be flush to
frame bracket Using a spring loaded center punch, mark the location that needs to be drilled with a
21/64" drill bit.
Tab reinforcement to the support bracket must be correctly aligned, max gap allowed is 2mm
between lower U-bracket and seat frame.
Advertisement
Table of Contents
