Canon Color imageCLASS MF8380Cdw Starter Manual page 14

Performing Color Correction
Color correction takes approximately 165
seconds.
Make sure that paper is
loaded, and then press [OK].
Supported Paper:
Size: A4, LTR, 16K
Type: Plain, Rec
OK
Confirm the procedure for the color correction, and
then press [OK].
Steps (Start:Press OK)
1. Print Adj. Image
2. Scan Adj. Image
A test chart (adjustment image) is printed.
Place the test chart on the platen glass with the
print side face down.
Place the paper so that the black stripe is at the back
side of the machine.
Press [ ] (Start).
Remove the test chart (adjustment image) placed
on the platen glass in Step
14
Check the temperature of the installation site
If the room temperature is low, correction may not be performed properly.
If <Adjustment failed.> appears
• Is the paper loaded correctly?
→ Load plain paper or recycled paper of A4/Letter size in the paper cassette.
• Is the test chart placed on the platen glass correctly?
→ Place the test chart with the print side face down and the black stripe toward the
back of the machine.
• Has a paper jam occurred?
→ Remove the jammed paper.
If you want to perform color correction again, press [
select the following settings in the following order.
→ <Adjustment/Maintenance> → <Auto Gradation Adjustment> → <Copy Image
Adjustment>
Step 1
Printing adjustment
image...
Place adjustment Step 2
image on the glass Scanning adjustment
with black side image...
toward the back.
Press Color to start.
.
] (Menu), and then
Open the feeder.
Close the feeder.
Copy Image Adjustment