Table of Contents
Advertisement
IDENTIFICATION OF CONTROLS
REAR PANEL
PHONO
CD
VIDEO
AUX
MM
1
2
3
4
ATTENTION!
Please make sure that the C 316BEE is powered off or unplugged before making any connections. It is also advisable to power down or unplug all
associated components while making or breaking any signal or AC power connections.
1 PHONO INPUT
•
Input for a turntable. This unit is compatible with turntables
equipped with a moving magnet (MM) phono cartridge.
•
Use a twin RCA-to-RCA lead to connect the turntable's left and right
"Outputs" to this input.
2 CD INPUT
•
Input for a CD or other line-level signal source.
•
Use a twin RCA-to-RCA lead to connect the CD player's left and right
"Audio Outputs" to this input.
3 VIDEO INPUT
•
Input for the audio signal from a stereo VCR (or stereo TV/Satellite/
Cable receiver) or other line-level audio source.
•
Using twin RCA-to-RCA leads, connect to the left and right "Audio
Outputs" of the unit to these inputs.
NOTE
These are audio inputs only.
4 AUX INPUT
•
Input for additional line level input signals such as another CD
player.
•
Use a twin RCA-to-RCA lead to connect the auxiliary unit's left and
right "Audio Outputs" to this input.
5 TUNER INPUT
•
Input for a tuner or other line-level signal source.
•
Use a twin RCA-to-RCA lead to connect the tuner left and right
"Audio Outputs" to this input.
8
TUNER
5
6
6 SPEAKERS
•
Connect the right speaker to the terminals marked "R +" and "R-"
ensuring that the "R+" is connected to the "+" terminal on your
loudspeaker and the "R-" is connected to the loudspeaker's "-"
terminal. Connect the terminals marked "L+" and "L-" to the left
speaker in the same way.
•
Always use heavy duty (16 gauge; 1.5mm, or thicker) stranded
wire to connect loudspeakers to your C 316BEE. The high-current
binding post terminals can be used as a screw terminal for cables
terminating in spade or pin sockets or for cables with bare wire
ends.
•
The C 316BEE is designed to produce optimum sound quality when
connected to speakers with impedances within its operating range.
Please make sure that all the speakers are rated 4 ohms minimum
per speaker.
7 AC POWER CORD
•
Connect AC power cord only to the prescribed AC Outlet, i.e., 120V
60 Hz or 230V 50 Hz.
8 POWER SWITCH
•
The POWER switch supplies the master AC mains power for the
C 316BEE. When this switch is in the ON position, the unit is in
standby mode, as shown by the amber status condition of the
standby LED.
•
Press the front panel's STANDBY button to turn ON the C 316BEE or
press again to return to standby mode.
•
Switch off the POWER switch if you intend not to use the C 316BEE
for long periods of time (such as when on vacation).
•
If the rear panel POWER switch is switched off the C 316BEE cannot
be turned ON using the front panel STANDBY button or AMP 4
remote control's [ON] button.
7
© NAD C 316BEE v2
8
Advertisement
Table of Contents
