NAD C316BEE Owner's Manual
  1. Manuals
  2. Brands
  3. NAD Manuals
  4. Amplifier
  5. C316BEE
  6. Owner's manual

NAD C316BEE Owner's Manual

Hide thumbs Also See for C316BEE:

Advertisement

Table of Contents

See also: Service Manual
C 316BEE
®
Stereo Integrated Amplifier
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for NAD C316BEE

Summary of Contents for NAD C316BEE

  • Page 1 C 316BEE ® Stereo Integrated Amplifier Owner’s Manual...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR LATER USE. 14 Outdoor Antenna Grounding - If an outside antenna or cable system FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE is connected to the product, be sure the antenna or cable system is AUDIO EQUIPMENT.
  • Page 3 24 Headphones - Excessive sound pressure form earphones and Changes or modifications to this equipment not expressly approved by headphones can cause hearing loss. NAD Electronics for compliance could void the user’s authority to operate 25 Battery Disposal - When disposing of used batteries, please comply this equipment.

  • Page 4: Notes On Environmental Protection

    Serial no.: ........NAD is a trademark of NAD Electronics International, a division of Lenbrook Industries Limited...

  • Page 5: Getting Started

    If the unit is not going to be used for some time, disconnect the plug from the AC socket. Should water get into your NAD C 316BEE, shut off the power to the unit and remove the plug from the AC socket. Have the unit inspected by a qualified service technician before attempting to use it again.

  • Page 6: Identification Of Controls

    FRONT PANEL 1 STANDBY: With the rear panel POWER switch set to ON position, 4 INPUT SELECTORS: These buttons select the active input to the NAD press this button to switch ON the C 316BEE from standby mode. C 316BEE and the signal sent to the loudspeakers or headphones. The The Standby LED indicator will turn from amber to blue.
  • Page 7 IDENTIFICATION OF CONTROLS FRONT PANEL 7 TONE CONTROLS: The NAD C 316BEE is fitted with BASS and TREBLE tone controls to adjust the tonal balance of your system. The 12 o’clock position is “flat” with no boost or cut, and an indent indicates this position.

  • Page 8: Rear Panel

    IDENTIFICATION OF CONTROLS REAR PANEL ATTENTION! Please make sure that the C 316BEE is powered off or unplugged before making any connections. It is also advisable to power down or unplug all associated components while making or breaking any signal or AC power connections. 1 DISC INPUT: Input for additional line level input signals such as CD, 7 SPEAKERS: Connect the right speaker to the terminals marked “R +” Mini Disc player or the output signal from a step-up amplifier for a and “R-”...
  • Page 9 The AMP 1 remote control handset handles the key functions of the C 316BEE. It has additional controls to remotely operate NAD CD Players. It will operate up to a distance of 23ft (7m). When a command from the remote control is received, the Standby LED indicator will blink.

  • Page 10: Troubleshooting

    REFERENCE TROUBLESHOOTING CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS • Power AC lead unplugged or power not • Check if AC lead is plugged in and power switched ON. switched ON. No sound. • Mute on. • Switch off Mute. • Balance control not centered. •...

  • Page 11: Line Level Input

    5 CCIF IM distortion, 19 + 20kHz rated output 6 Gross dimensions include feet, volume knob and extended speaker terminals Specifications are subject to change without notice. For updated documentation and features please log onto www.nadelectronics.com for the latest information about your C316BEE.
  • Page 12 ©2010 NAD ELECTRONICS INTERNATIONAL A DIVISION OF LENBROOK INDUSTRIES LIMITED All rights reserved. No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International C 316BEE Owner’s Manual Issue 1.4-04/10...

Table of Contents