Table of Contents
Advertisement
REFERENCE
TROUBLESHOOTING
CONDITION
No sound.
No sound one channel.
Weak bass/diffused stereo image.
Remote control handset not working.
Standby LED turns red during operation.
10
POSSIBLE CAUSES
• Power AC lead unplugged or power not
switched ON.
• Mute on.
• Balance control not centered.
• Speaker not properly connected or damaged.
• Input lead disconnected or damaged.
• Speakers wired out of phase.
• Battery flat or incorrectly inserted.
• IR transmitter or receiver windows obstructed.
• IR receiver in direct sun or very bright ambient
light.
• C 316BEE has overheated.
• Overall impedance of loudspeakers too low.
POSSIBLE SOLUTIONS
• Check if AC lead is plugged in and power
switched ON.
• Switch off Mute.
• Center Balance control.
• Check connections and speakers.
• Check leads and connections.
• Check connections to all speakers in the
system.
• Check or replace battery.
• Remove obstruction.
• Place unit away from direct sun, reduce
amount of ambient light.
• Turn C 316BEE OFF; make sure ventilation
slots on top and bottom of C 316BEE are not
blocked. After C 316BEE has cooled down, turn
back ON.
• Ensure the overall loudspeaker impedance is
not below 4 ohms.
Advertisement
Table of Contents
