Table of Contents
Advertisement
About this task
The following image(s) indicate the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
4. Adhere the tape over the screw on the I/O board.
5. Connect the coin-cell battery to the I/O board.
6. Connect the I/O-board cable to the I/O board and close the latch.
7. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
8. Replace the two screws (M2.5x4) that secure the left-display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components
43
Advertisement
Table of Contents
