INSTALLATION
INSTRUCTIONS
INSTALLATION REQUIREMENTS
Tools and Parts
Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open end
wrenches 15/32" (12 mm)
and 1/2" (13 mm)
4" min
(102 mm)
Wood block
Pliers that open to 1
⁄
"
9
16
(39.5 mm)
Parts supplied:
NOTE: All parts supplied for installation are in the washer
basket.
Cable tie
U-shaped hose form
14
Level
Ruler or measuring tape
Inlet hoses (2) with
washers
Transport bolt hole
plugs (4)
Optional tools:
Flashlight
Options:
Pedestal:
You have the option of purchasing a pedestal for this washer.
You may select an 11.8" (300 mm) pedestal. The pedestal will
add to the total height of the washer.
Pedestal
Approximate
Height
Height with
Washer
11.8" (300 mm)
44.7" (1135 mm)
Alternate parts:
(Not supplied with washer)
Your installation may require additional parts. To order, please
refer to toll-free numbers on the back page of this manual.
If you have:
Laundry tub or standpipe Sump pump system (if not already
taller than 55" (1.4 m)
Overhead sewer
Floor drain system
Drain hose too short
Water faucets beyond
reach of fill hoses
Stack Kit:
Are you planning to stack your washer and dryer? To do so you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your washer
or refer to the "Assistance or Service" section. Ask for Part
Number W10178021.
Bucket
Color
Model
Number
White
LAB0050PQ
You will need:
available)
Standard 20 gal. (76 L) 30" (762 mm)
tall drain tub or utility sink, sump
pump and connectors (available from
local plumbing suppliers)
Siphon Break Kit Part Number 285834
Connector Kit (x2) Part Number 285835
Additional Drain Hose Part
Number 8318155
Extension Drain Hose Part
Number 285863
Connector Kit Part Number 285835
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008