Table of Contents
Advertisement
If a problem occurs ...
Reacting to messages displayed on the display panel
1
Message
Possible cause
No radio link can be established. The
No link
transmitter is switched off or out of
range.
The received radio signal is very weak
Bad link
or of bad quality.
The batteries or the accupack of the
Low battery
received transmitter are/is flat.
The transmitter cannot be muted
Mute disabled
because the
deactivated.
Muted
The transmitter is muted.
1
In addition, the background of the display panel changes back and forth between light and dark.
If a problem occurs that is not listed in the tables or if the problem cannot be solved with the proposed solutions, please
contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at
www.sennheiser.com
under "Service & Support".
MUTE
switch is
Possible solution
• Switch the transmitter on.
• Keep a free line of sight between the transmitter
and the receiver and reduce the distance between
the devices.
• Hold the handheld transmitter correctly.
• Use the Walk Test menu item to check the
reception quality and avoid areas without
reception.
• Keep a free line of sight between the transmitter
and the receiver and reduce the distance between
the devices.
• Hold the handheld transmitter correctly.
• Use the Walk Test menu item to check the
reception quality and avoid areas with bad
reception.
• Insert new batteries.
• Recharge the accupack.
Activate the
MUTE
switch.
Set the
MUTE
switch to the position MIC.
Page
26
15
24
37
15
24
37
22
25
35
28
45
Advertisement
Table of Contents
