Stereo Audio; Network Cabling; Placement Of Ethernet Ports On The Back Panel Of The Connectstation - Sennheiser MobileConnect User Documentation

ANALOG IN:
Four analog jack inputs are available.
►

Stereo audio

Note: Stereo audio is disabled by default.
To enable and configure stereo streaming please go to the
▷
section of the admin interface (see "Access and initial configuration").
For stereo audio you have to combine two mono audio inputs. More de-
▷
tails regarding cabling see above.

Network cabling

For further information also refer to "Selecting the network mode".

Placement of Ethernet ports on the back panel of the ConnectStation

The ConnectStation provides three Gigabit Ethernet ports that are alloca-
ted to different funtionalities:
►
LAN 1
Standalone Mode:
▷ LAN1 is used to connect a delivery subnet in Standalone Mode.
LAN2 is used to integrate into an existing network as a client. In Stan-
▷
dalone mode, this network is only used to connect to the Internet for
service and support.
Integrated Mode:
LAN1 is disabled when the ConnectStation is set to Integrated Mode.
▷
▷ LAN2 is used to integrate into an existing network as a client. In Integ-
rated mode, all stream delivery to clients will be via LAN2, and it is used
to connect multiple ConnectStations into a cluster.
Both modes:
LAN3 is used to connect a laptop for administrative access. It can only
▷
be configured to have a static IP address and netmask (no DHCP), and
not gateway or DNS server.
Note: There is no routing between any of these networks, i.e. clients ac-
cessing the WiFi connected to LAN1 cannot access any network resources
connected via LAN2.
LAN 2 LAN 3
Installation
Audio Inputs
40