Table of Contents
Advertisement
Using the products
EQ DE-S AGC
NAME
10 h
Audio out:
845
Low cut filter:
ATTENTION
Breakdown of radio links during the firmware update
All radio links are subject to interference during the firmware update pro-
cess and can therefore not be used for audio transmission.
Never update the firmware during a performance.
Identifying paired devices
You can perform a pairing identification to see which transmitter is paired
with which receiver.
Switch on all devices whose pairing you want to identify (see page 26).
Short-press the
The status LEDs of the paired devices flash for 10 seconds. Identify appears
on the receiver display panel. This is plus the name of the radio link appear
on the transmitter display panel.
If the receiver or the transmitter is not paired or if the paired device is not
switched on or out of range, the display panel changes back to the standard
display after 10 seconds.
Using the devices in multi-channel operation
If you only want to use up to six radio links simultaneously, you do not have
to follow a special switch-off/switch-on sequence. If you want to use more
than six radio links simultaneously, you may have to follow a special switch-
off/switch-on sequence.
Proceed as described in the enclosed "Multichannel Operation" leaflet.
Switching between the standard display and the
extended standard display
To switch from the standard display to the extended standard display:
Turn the jog dial to the left.
After 10 seconds, the display panel automatically changes from the
extended standard display back to the standard display.
To manually change from the extended standard display back to the standard
display before 10 seconds have elapsed:
Turn the jog dial to the right.
10 dB
Off
PAIR
button of the receiver or of the transmitter.
29
Advertisement
Table of Contents
