System Board - HP Compaq dx6100 MT Reference Manual

6.16 System Board

1. Prepare the computer for disassembly
2. Remove the access panel and rotate the computer so the system board is parallel to the table
to make it easier to work on
3. Remove all PCI expansion boards
4. Disconnect all cables connected to the system board, noting their location for reinstallation.
5. Remove the 3-1/4" drives from the drive cage to make it easier to handle the system board.
6. Remove the eight screws that secure the system board to the chassis then, slide the system
board towards the front of the chassis to remove it.
To install the system board, reverse the removal procedures.
Service Reference Guide, dx6100
Removal and Replacement Procedures— Microtower (MT) Chassis
(Section 6.1, "Preparation for
(Section 6.3, "Access Panel").
(Section 6.8.2, "Standard PCI Expansion
361293-002
Disassembly").
Card").
6–31