LENCO 8711902066156 User Manual page 13

IMPORTANT INFORMATION REGARDING DAB+ RECEPTION
DAB+ radio reception is different from FM radio reception.
•
In FM, you can often still receive a weak station, but probably with a rustling or crackling sound.
•
DAB + reception works digitally and if there is not enough signal you hear nothing. No hiss or crackle as
with FM. This is not due to the radio, but to the fact that there is not enough DAB+ signal at that
location.
•
DAB + rule is: no or weak reception = no sound.
What can you do if you do not have direct DAB+ reception.
•
Always point the antenna straight up vertically first.
•
Do not place the radio too close to potential sources of interference such as, battery chargers, rotating
machinery, computers, large metal surfaces, etc.
•
Move the radio a few meters.
•
Turn on the radio and activate a full scan in the DAB+ menu
•
In the display of the radio you will see the progress of the scan and the number of stations found in
the current position of the radio.
Important
•
With DAB+ reception, there can be a very big difference in reception level between one location and
"a few meters away". In case of a local weak DAB+ signal, move the radio to find a stronger signal.
•
If you take the radio to another location, perform a full scan again. This will show you which DAB+
stations can be received there.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Press the MODE key to select "FM".
Long Press
2.
sufficient signal strength.
After a few seconds, the display will update. The display will show the station frequency. If the signal
3.
is strong enough and the station signal contains RDS data, then the radio will display the station
name.
To find other stations, press and hold the
4.
5. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
Manual Scan
Press the MODE key on the main unit to select "FM Mode''.
1.
2. Select FM mode as previously described, if required.
3. Press or
down by 50 kHz.
button, and your radio will scan and stop automatically when it finds a station of
shortly adjust tuning. Each press of the tuning button will change the frequency up or
button as before.
- EN 13 -