Table of Contents
Advertisement
2.1 Management Mode
The NWA1000 Series is a hybrid access point, which means it can work either in standalone mode or in
Nebula Cloud Management Mode (cloud mode).
Standalone
By default, the NWA1000 Series serves as a normal AP and is to be configured using its built-in web
configurator or CLI (Command Line Interface), See
about the web configurator screens.
Nebula Cloud Management
In this mode, you can manage and monitor the NWA1000 Series through the Zyxel Nebula cloud-based
network management system. See the NCC (Nebula Control Center) User's Guide for how to configure
Nebula managed devices. See
VLAN setting or manually set its IP address.
2.1.1 Mode Changing
This section describes how to change the NWA1000 Series's management mode.
From Standalone to Cloud
To manage your NWA1000 Series via the Zyxel NCC, connect the NWA1000 Series to the Internet and
register it to a site and organization in the NCC (http://nebula.zyxel.com) first using its serial number and
MAC address or its QR code. The serial number, MAC address and QR code can be found in the web
configurator dashboard or the label on the device. See the corresponding Quick Start Guide for how to
do hardware connections and device registration.
Note: The NWA1000 Series automatically goes into cloud mode after it can access the NCC
through the specified proxy server (if any) and is successfully registered in the NCC. Its
login password and wireless settings are then overwritten with what you have
configured in the NCC.
From Cloud to Standalone
To return to the default standalone mode, just click Unregister to remove the NWA1000 Series from the
organization/site in the NCC. The NWA1000 Series will reboot and restore the factory default settings.
Chapter 2 Management Modes
Management Modes
Chapter 23 on page 191
NWA1000 Series User's Guide
C
H A P T E R
Chapter 4 on page 31
if you want to change the NWA1000 Series's
16
2
for detailed information
Advertisement
Table of Contents
Troubleshooting
