Trigger Mode - Omron STC-MBS322U3V Product Specifications And User's Manual

7.2

Trigger Mode

This trigger consists of Frame Start, Exposure Start and Exposure End.
1) Frame Start
This function has the capability to acquire an image from exposure through the trigger.
The Frame Start function can be enabled when "Frame Start" is selected on Trigger Selector and the Trigger mode
is set to "On".
This function supports "Edge Preset" trigger and "Pulse Width" trigger with trigger signal. This function can control
exposure through Exposure Mode.
2) Exposure Start, Exposure End
This function has the capability to acquire an image from Exposure Start to Exposure End. Exposure Start trigger
is pair of Exposure End.
Exposure Start and Exposure End are selectable on Trigger Selector. Exposure Start function and Exposure End
function can be enable through each Trigger Mode On.
This function is only enabled when Exposure Mode sets Trigger Controlled. If Exposure Mode did not set Triger
Controlled, camera exposure and image acquisition do not work.
(*) Please do not apply the Trigger through maximum frame rate on Trigger Mode. When Trigger applies within sensor
Readout as exposure end, camera interrupted Readout.
STC-MBS322U3V / STC-MCS322U3V / STC-MBS510U3V / STC-MCS510U3V
Product Specifications and Use's Guide
No.15S013-02
31/67