Advertisement
Step 4
BW16
The rear fl oor frame is made up of 2
pieces. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. The
illustration below shows the proper
overall length for the rear.
1
Overlap right and left rear frames,
align holes, and fasten using 8 bolts
and nuts. Make 3 assemblies. Use
1 assembly for this step.
7560
7517
Side Frame
Notch toward outside
of building
STEP
4
7837
#10-32x1/4" (6 mm)
Bolt
7835
Parts Needed For
Floor Frame Assembly
12x10 (3,6 m x 2,8 m)
2
Position fl oor frames as shown
and fasten at each corner using 2
bolts through the bottom and nuts
on top.
3
Measure the fl oor frame diago-
nally. When the diagonal measure-
ments are equal, the fl oor frame is
square.
Slot
7560
7517
STEP
3
#10-32 Square Nut
7834
4
on either side, toward the rear of
building. Install lower door track
and ramp, notch toward outside,
using 1/4" (6 mm) bolts and nuts,
as shown. See Step 12 for Rear
Door Installation.
Do not fasten the fl oor frames to
your foundation at this time. You
will anchor the building after it is
erected.
The fl oor frame must be square
and level or holes will not align.
STEP
1
8531
Position with small holes
toward outside of building
16
8532 Right Rear Frame (1)
8531 Left Rear Frame (1)
7837 Side Frame (2)
7834 Right Front Frame (1)
7835 Left Front Frame (1)
7517 Lower Door Track (1)
7560 Ramp (1)
Select location of side door
NOTE
Rear Frame 140 7/8"
357,8 cm
Level
8532
#10-32x7/16" (11 mm) Bolt
7837
STEP
2
Advertisement
