Pioneer PDM-4001 Technical Manual page 129

2 ) Ceiling-suspension metal fixture for plasma display (PDK-4002 / PDK-4003 / PDK-4004)
When a ceiling suspension metal fixture is to be mounted to the plasma display with the optional speaker, use the
monitor mounting bolt to tighten the display and speaker, as shown in Fig.2. Then, as shown in Fig.3, use the φ 25-mm
washers supplied with the optional speaker and the monitor mounting bolts not used to fix the speaker at the center
section to tighten the assembly, . Follow the usual steps for mounting the normal ceiling suspension metal fixture.
After mounting the optional speaker, it will be difficult to see the monitor mounting bolts. Take appropriate precautions
when mounting the optional speaker.
Monitor-mounting bolt
(supplied with the PDK-
4002, PDK-4003, PDK-
4004)
Monitor-mounting bolt
(supplied with the PDK-
4002, PDK-4003, PDK-
4004)
Ceiling-suspension metal fixture
for plasma display
This shows the PDK-4002. The same illustration applies to the PDK-4003 and PDK-4004. Optional speakers mounted to
both sides of the PDK-4003 may interfere with each other, depending on the specific tilt or angle.
Mounting standard metal fixtures
(Precautions for installing the optional speaker)
Monitor mounting bolt
(supplied with the ceiling suspension
metal fixture for the plasma display)
Fig. 2
Hole rivet
Washer of φ 25-mm outer diameter
(supplied with optional speaker)
Fig. 3
129