Section 5: Setting The Real-Time Clock; General Information; Setting The Time And Date - Honeywell VISTA-250FBPT Installation And Setup Manual

Section 5: Setting the Real-Time Clock

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

General Information

This system provides a real-time clock, which must be set in order for the system's event log to keep track of events by
time and date. It must also be set in order to execute scheduling programs (Time-Driven events).
Only users with Installer or Master authority level can set the clock.

Setting the Time and Date

To set the real time clock, perform the following steps:
Step Action
1 Enter Installer or Master Code + [#] 63. Typical display shows:
TIME/DATE – THU
12:01am
The day of the week is automatically calculated based on the date entered. Time and date entries are made by
simply entering the appropriate hour, minute, month, day and year.
Press [ ∗ ] to move the cursor to the right of the display, to the next position.
Press [#] to move the cursor to the left of the display, to the previous position.
2
Enter the correct hour. Then press [
3
Enter the correct minutes. Press [
4
Press any key 0-9 to change AM to PM, or PM to AM. Press [
5
Enter the correct month using a 2-digit entry. Press [
6
Enter the correct day using a 2-digit entry. Press [
7 Enter the correct year.
∗
Press [ ] to continue.
8
Press [ ∗ ] to exit the real-time clock edit mode.
01/01/09
∗
] to move to the "minutes" field.
∗ ] to move to the AM/PM position.
∗
] to move cursor to the "month" field position.
∗ ] to move cursor to the "day" field position.
∗ ] to move cursor to the "year" field position.
61