Door Alarm; Door Alarm And Volume Adjustment Of The Operation Sound; Set The Condensation Prevention Heater To Min - Hitachi R-E5000S How To Use Manual

Door Alarm

When the door is opened for more than 1 minute, sound and light occur indicating the door is open as shown in the table below.
No Door Alarm is installed in the Upper Freezer.
Duration when door is open
Alarm sound
※ When the door is left open for one minute or more, the indicator lamp blinks and the characters on the Control Panel is illuminated.
※ From 30 seconds onwards with the door opened, the Door Alarm sounds only when the energy saving mode is set. (The indicator lamp blinks when
the door is left open for one minute or more)
※ When the indicator lamp on the display area blinks due to the Door Alarm function, the Control Panel will not be activated by touching it.

Door Alarm and volume adjustment of the operation sound

You can set the sound level of the alarm louder or no alarm sound.
Touch
1
on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
2
Press down
until the preset sound is heard.
The volume level of the operation sound is changed from " Standard " to " Louder "
or " Sound off " . Repeat the change of settings to set the operation sound you like
(see the table shown below). The sound is set to " Standard " before shipping.
Volume level
Standard
Preset sound
(Factory setting)

Set the condensation prevention heater to MIN.

Setting the condensation prevention heater to MIN saves energy.
When dew is formed in the partitioning iron plates, set it to the standard.
The temperature settings for the partitioning iron plates can be adjusted by four levels (1 to 4), and level 4 is
the most energy saving.
MIN setting of the heater
Preset sound
Setting the partition iron plate
1
Open the door of the Lower Freezer
Compartment.
2 Touch
Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are
displayed.
● The setting will be returned to the standard when the power plug is disconnected and connected or power failure recovery takes place.
Notice
BB0040171T_R-E5000SHV_A.indd 55
1 minute
Long beep (3 beeps)
button on the Control Panel to turn
button for 3 seconds or more
Louder Sound off
−
2 long beeps Long beep
Standard MIN setting level 1 MIN setting level 2 MIN setting level 3 MIN setting level 4
−
Long beep
(Factory setting)
button on the Control
2 minutes
Long beep (5 beeps)
Notice
● It is impossible to adjust the volume level of
either door alarm or operation sound only.
● When the Door Alarm is disabled, characters
on the Control Panel no longer blink.
● Even if the volume level is set to " Sound off " ,
the alarm of the Ice Maker Cleaning and the
operation sound when the AUTO DOOR of
the Refrigerator Compartment and the AUTO
DOOR are set to "ON" will sound.
● When connecting/disconnecting the power
Standard
plug or after recovering from electric power
2 beeps
failure, it will return to the standard setting
where the Door Alarm sounds.
(Partitioning iron plates)
Long beep (2 beeps) Long beep (3 beeps) Long beep (4 beeps)
3
Press down
more until the preset sound is heard.
The setting of MIN level of the dew condensation prevention
heater will be switched.
Repeat the above-stated operation to set it to the level you
prefer (see the table above).
4
Close the door of the Lower Freezer
Compartment.
3 minutes
Long beep (continuously), Louder
Partitioning iron plates
Standard
2 beeps
button 3 seconds or
55
15.4.7 1:50:39 PM