Table of Contents
Advertisement
GENERAL PRODUCT GUIDELINES
2.5
SERVICE CONNECTION GUIDELINES
2.5.1 Gas Inlet Connection
•
All piping must be in accordance with AS/NZS 5601 and any local gas regulations.
•
The connection point for universal and external model heaters is a female G3/4 compression fitting to AS 3688.
This is either located on the outer cabinet of the heater, or supplied loose within the heater.
•
The connection point for internal model heaters is a male G3/4 compression fitting to AS 3688.
•
A gas cock shall be fitted in the gas line adjacent to the heater and in a convenient location so it can be turned
OFF quickly and easily.
•
The gas supply shall in no way interfere with any servicing of the heater.
The gas supply must be installed by a licensed gas fitter. The gas pipe and gas meter should be
sized so the heater can maintain its required incoming gas pressure at maximum consumption
with all other gas appliances operating at their maximum capacity at the same time as the heater.
NOTE
2.5.2 Electrical Power Supply
The heater is pre-wired with a 3-pin plug and lead, and shall be plugged into a standard 10 Amp 220-240V fixed
switched socket outlet adjacent to the heater in a convenient location so it can be turned OFF quickly and easily.
A qualified electrician must install the 220 to 240 volt wiring according to local regulations.
NOTE
Switch OFF the power and unplug the heater before touching any wiring. If any electrical wiring
is damaged, it must be replaced by the manufacturer, its service agents or an electrically
qualified technician, in order to avoid a hazard.
IMPORTANT
The electricity supply must be 220-240V at 50Hz, and supplied by an authorised power supplier. Generators should
never be used to supply this system as their output may be incompatible with, or prone to damage electronic
components of the heater.
Rinnai
10
Ducted Gas Heater IM
Advertisement
Table of Contents
