Symbols; Features - Ryobi PBLCK01K Operator's Manual

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Safety Alert
Read Operator's Manual
Eye Protection
Wet Conditions Alert
Recycle Symbol
V Volts
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute
PRODUCT SPECIFICATIONS
(PBLDD01 Drill-driver)
Chuck .......................................................... 1/2 in., Keyless
No Load Speed ................................ Low 0-500/min (RPM)

SYMBOLS

MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand operator's
manual before using this product.
Always wear eye protection with side shields marked to comply
with ANSI Z87.1.
Do not expose to rain or use in damp locations.
This product uses lithium-ion (Li-ion) batteries. Local, state, or
federal laws may prohibit disposal of batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute

FEATURES

High 0-2,100/min (RPM)
DESIGNATION/EXPLANATION
PRODUCT SPECIFICATIONS
(PBLID01 Impact Driver)
Speed .................................................... 0-2,900/min (RPM)
Collet ......................................................................... 1/4 in.
Impacts per minute .................................0-4,000/min (IPM)
Torque ............................................................0-2,200 in.lbs.
5 - English