HP ProSignia 120 Maintenance And Service Manual page 32

Error Code Description
101-xx CPU test failed.
103-xx DMA page registers test failed.
104-xx Interrupt controller master test failed.
105-xx Port 61 error.
106-xx Keyboard controller self-test failed.
107-xx CMOS RAM test failed.
108-xx CMOS interrupt test failed.
109-xx CMOS clock test failed.
110-xx Programmable timer load data test failed.
113-xx Protected mode test failed.
Error Code Description
200-xx Memory machine ID test failed.
202-xx Memory system CMOS checksum failed.
203-xx Write/Read test failed.
204-xx Address test failed.
211-xx Random pattern test failed.
214-xx Noise test failed.
215-xx Random address test failed.
Error Code Description
300-xx Failed ID Test.
301-xx Failed Self test/Interface Test.
302-xx Failed Individual Key Test.
304-xx Failed Keyboard Repeat Test.
Error Code Description
401-xx Printer failed or not connected.
402-xx Failed Port Test.
403-xx Printer pattern test failed.
2-10 Troubleshooting
Table 2-5
Processor Test Error Codes
Recommended Action
Replace the processor board and retest.
Replace the system board and retest.
Table 2-6
Memory Test Error Codes
Recommended Action
The following steps apply to error codes 200-xx
and 202-xx:
1. Flush the system CMOS and retest. See note.
2. Replace the system board and retest.
The following applies to error codes 203-xx
through 215-xx:
Remove and replace the SODIMM memory board
or system board (if the memory on the system
board is faulty) and retest.
Table 2-7
Keyboard Test Error Codes
Recommended Action
1. Reseat the keyboard assembly.
2. Replace the keyboard and retest.
3. Replace the system board and retest.
Table 2-8
Parallel Printer Test Error Codes
Recommended Action
1. Connect the printer.
2. Check power to the printer.
3. Install the loopback connector and retest.
4. Check port and IRQ configuration.
5. Replace the system board and retest.