7.
Lift the bezel (4) until it disengages completely.
8.
If it is necessary to replace the webcam module, gently pull the webcam module away from the
double-sided tape on the display enclosure (1) and disconnect the webcam cable from the module
(2). The webcam module and cable can be ordered by using spare part number 598671-001.
NOTE:
To replace the webcam module in the display enclosure, align the holes on the webcam
module with the pins on the display enclosure and press onto the double-sided tape.
9.
If it is necessary to replace the display hinges, remove the two Torx M2.5×5.0 screws (1) at the
top of the display and then the two Torx M2.5×6.0 screws (2) that secure the hinges to the
display housing.
Component replacement procedures
89