NordicTrack NCTL19920 User Manual page 7

4. Cut the plastic tie holding the Upright Wire Harness (98)
in the right Upright (69). Have a second person hold the
Handrails (66) near the Uprights as shown. Connect the
Upright Wire Harness to the wire harness extending from
the Console Base (81). The connectors should slide
together easily and snap into place. If they do not,
turn one connector and try again. Then, insert the con-
nectors and the Upright Wire Harness into the hole in the
right Upright. Set the Handrails on the Uprights, being
careful not to pinch the wires.
5. Insert two Handrail Bolts (78) with Handrail Washers (77)
into the right Upright (69) and the right Handrail (66). Be
careful not to damage the Upright Wire Harness (not
shown). Next, lift the right Handrail (66) slightly and align
the Bolts with the holes in the Handrail. Thread the Bolts
into the Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Then, tighten all four Handrail Bolts (78).
6. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor. For your benefit, familiarize yourself with the information on pages 28 and 29.
4
66
5
66
7
81
98
69
69
77
78