HP OmniBook XE2 Evaluator Manual page 20

Operating the OmniBook XE2
Configuring the OmniBook with the BIOS Setup Utility
Secondary Master
Display Device
PS/2 Mouse
ZV Port
Quiet Boot
System Memory
Extended Memory
Advanced Menu
Serial port
Base I/O
address
IrDA port
Mode
Base I/O
address
DMA channel
Parallel Port
Mode
Base I/O
address
DMA channel
Local Bus IDE
Adapter
2-4
Sets the CD-ROM drive type and various
parameters.
Switches between the built-in display
(LCD), an external display (CRT) if
attached, and both.
Enables or disables an external PS/2
mouse, when one is connected.
Sets whether zoomed video function is
enabled, to connect from a PC card to a
VGA controller.
When enabled, hides summary of
power-on self-test and messages during
boot.
Shows the system memory size.
Shows the extended memory size.
Sets how the serial port is configured by
the BIOS (specified or automatic).
Sets the I/O address and interrupt.
Sets how the infrared port is configured
by the BIOS (specified or automatic).
When IrDA port is enabled, sets the
hardware to support SIR (Standard IR) or
FIR (Fast IR) infrared communications.
(Driver installation is required.)
When IrDA port is enabled, sets the I/O
address and interrupt.
When Fast IR mode is enabled, sets the
DMA channel.
Sets how the parallel port is configured
by the BIOS (specified or automatic).
Sets the port to output only, bi-
directional, ECP mode, or EPP mode.
Sets the I/O address.
When ECP mode is enabled, sets the
DMA channel.
Enables the primary (hard drive) and
secondary (CD-ROM drive) controllers.
CD-ROM drive
detected and
set
automatically.
LCD/CRT
Enabled
Enabled
Enabled
640KB
Detected
automatically.
Default
Enabled
3F8 IRQ4
Disabled
SIR
2F8 IRQ3
DMA 3
Enabled
Bi-directional
378 IRQ7
DMA 1
Both