Table of Contents
Advertisement
• Separator Time Out
Example: Connect to Modbus sensor via Virtual COM mode
ICS-2400T
1.
Set Port Configuration as shown below.
2.
Set operation mode as VCOM mode.
User's Manual of ICS-2x00T Serial Device Server Series
Do nothing: it will pack the accumulated data including Separators.
Strip Separator: it controls striping of Separator from the received characters
before the received characters are sent to the network.
Separator timeout controls the maximum amount of time that can be used to buffer
characters before the characters are sent to the network. A smaller values will increase
the number of network packets, but reduce the amount of time to receive characters, on
the contrary, Larger values reduce the number of network packets, but increase the
amount of time to receive characters. The range of value is from 0 to 65535. The default
is 0 ms.
Figure 4-5-28: Virtual COM Mode Application
Figure 4-5-29: Port Configuration
Figure 4-5-30: VCOM Mode Configuration
62
Advertisement
Table of Contents
