Planet ICS-2102ST User Manual page 58

• Frame Length
• Separator
• Separator Process
• Separator Time Out
Connection Target IP address
Object
• Target IP address 1
through 4
Assign Local Port
Object
• Local listen port
• Connection control
User's Manual of ICS-2x00T Serial Device Server Series
achieve communication. The range of value is from 1 to 65535. The default is 5004 for
port 1, 5005 for port 2, 5006 for port 3 and , 5007 for port 4.
This parameter can be used to control the data packet. When the device port is in the
buffer until the specified data is accumulated, the data will be packed and transmitted by
the network. This parameter is 0 to indicate that the data will not be packed until the
buffer is full. The range of value is from 0 to 1024. The default is 0.
If the Separator is enabled, the serial receive character port will be discarded until the
start separator is detected on the serial port. When the end separator is received, the
buffered characters, including the start and end separators, are sent to the network.
The range of value is from 0 to FF. The default is disable.
Separators are ASCII characters specified by the user when configuring the serial serve.
This parameter describes how to control characters received on a serial port are sent
across the network. The default is Do nothing.

Do nothing: it will pack the accumulated data including Separators.

Strip Separator: it controls striping of Separator from the received characters
before the received characters are sent to the network.
Separator timeout controls the maximum amount of time that can be used to buffer
characters before the characters are sent to the network. A smaller values will increase
the number of network packets, but reduce the amount of time to receive characters, on
the contrary, Larger values reduce the number of network packets, but increase the
amount of time to receive characters. The range of value is from 0 to 65535. The default
is 0 ms.
Description
IP addresses are used to deliver packets of data across a network and have what is
termed end-to-end significance. The network data is sent to the device in a first-in,
first-out (FIFO) method. During data transfer phase, data is transmitted sequentially
through established path-arriving at the destination in the order in which it was sent.
Description
The range of value is from 1 to 65535. The default is 5004 for port 1, 5005 for port 2,
5006 for port 3 and , 5007 for port 4.
The default is Startup/None.

Startup/None

Any Character/None

Any Character/Quiescent time

DCD On/DCD Off

DCD On/None

DSR On/DSR Off

DSR On/None
58