Planet ICS-2102ST User Manual page 60

• Separator Process
• Separator Time Out
Connection Target IP address
Object
• Target IP address 1
through 4
User's Manual of ICS-2x00T Serial Device Server Series
buffered characters, including the start and end separators, are sent to the network.
The range of value is from 0 to FF. The default is disable.
Separators are ASCII characters specified by the user when configuring the serial serve.
This parameter describes how to control characters received on a serial port are sent
across the network. The default is Do nothing.

Do nothing: it will pack the accumulated data including Separators.

Strip Separator: it controls striping of Separator from the received characters
before the received characters are sent to the network.
Separator timeout controls the maximum amount of time that can be used to buffer
characters before the characters are sent to the network. A smaller values will increase
the number of network packets, but reduce the amount of time to receive characters, on
the contrary, Larger values reduce the number of network packets, but increase the
amount of time to receive characters. The range of value is from 0 to 65535 ms. The
default is 0 ms.
Description
IP addresses are used to deliver packets of data across a network and have what is
termed end-to-end significance. The network data is sent to the device in a first-in,
first-out (FIFO) method. During data transfer phase, data is transmitted sequentially
through established path-arriving at the destination in the order in which it was sent.
60