Display Assembly - HP Compaq Presario,Presario B1201 Maintenance And Service Manual

Display assembly

Description
12.1-inch, WXGA display assembly (includes WLAN antenna transceivers and cables, camera
module, and camera module cable)
Before removing the display assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Disconnect the wireless antenna cables from the WLAN module (see
5.
Remove the keyboard (see
6.
Remove the switch cover (see
7.
Remove the display assembly:
Close the computer and turn it upside down, with the rear panel toward you.
1.
Remove the Phillips PM2.5×7.0 screw (1) and Phillips PM2.5×5.0 screw (2) that secure the display
2.
assembly to the computer.
Turn the computer right-side up, with the front toward you.
3.
Open the computer as far as possible.
4.
54 Chapter 4 Removal and replacement procedures
Battery on page 37).
Keyboard on page 50).
Switch cover on page
WLAN module on page
52).
Spare part number
454003-001
45).