Charging The Battery Pack; Work Piece And Work Area Set Up; General Operating Instructions - Chicago Electric 67845 Set Up And Operating Instructions Manual

Charging the battery pack

Charger (36)
LED Light
Flanges
Figure 2
1. Plug the Adapter (37) into a 120V wall
outlet.
Battery Pack (35)
Figure 3
Align the flanges on the Charger (36)
2.
with the slots on the Battery Pack (35)
and slide the Charger onto the Battery
Pack.
Battery Pack (35)
Charger (36)
Figure 4
3. Plug the Adapter cord into the Charger.
The light on the Charger will turn on,
indicating that the Battery Pack is
Charging.
SKU 67845
Adapter (37)
Charger (36)
Flange
Adapter (37)
Adapter
Cord
For technical questions, please call 1-800-444-3353.
Charge for 2-1/2 to 3 hours, then unplug
4.
the Adapter from the wall and the
Charger, and remove the Charger from
the Battery Pack.
5. Allow the components to cool if they
are warm or hot to the touch. Store the
Adapter and Charger in the Storage
Case (38).
CautIon: Do not leave the Battery Pack
charging for more than 5 hours or the
Battery Pack may become damaged.
note: Initial charge and recharging is
approximately the same amount of time.

Work piece and Work area set up

1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Secure loose work pieces using a vise
or clamps (not included) to prevent
movement while working.
3. There must not be objects, such as utility
lines, nearby that will present a hazard
while working.

general operating Instructions

•
only use sockets designed for
impact wrench use.
•
Do not use sockets with drives smaller
than 1/2". You may use impact socket
adapters to use impact sockets with
drives greater than 1/2".
•
Do not exceed recommended bolt
capacity of 1/2"
•
only use socket extensions
designed for impact use.
•
To lock the Trigger (27), center the
Forward/Reverse Lever (26) on the
tool.
Page 9