Chicago Electric 67845 Set Up And Operating Instructions Manual page 10

•
To set the Impact Anvil (6) to turn
forward (clockwise), press the right
side of the Forward/Reverse Lever (26)
until it clicks into place.
•
To set the Impact Anvil (6) to turn in
Reverse (counterclockwise), press the
left side of the Forward/Reverse Lever
(26) until it clicks into place.
CautIon: To prevent possible gear damage,
always allow the Impact Anvil (6) to come
to a complete stop before changing the
direction of rotation.
basic operation
1. Charge the Battery Pack, but do not
attach it to the Impact Wrench yet.
Center the Forward/Reverse Lever (26)
2.
to lock the Trigger (27).
3. Slide the desired socket (sold separately)
onto the Impact Anvil (6).
Impact Wrench
Battery Pack (35)
Figure 5
Align the flanges on the bottom of the
4.
Impact Wrench with the slots on the
Battery Pack (35), and slide the Impact
Wrench onto the Battery Pack.
Page 10
Flange
For technical questions, please call 1-800-444-3353.
5. Set the desired direction of the Impact
Anvil (6) with the Forward/Reverse Lever
(26).
6. Position the socket over the fastener.
Holding the handle firmly with one hand
7.
and the top of the Housing (24 & 28)
with your other hand, gently squeeze the
Trigger (27).
note: This tool has a variable speed and
torque. Squeezing the Trigger more
tightly will increase the speed and torque
of the tool.
8. After tightening a fastener, check the
torque with a torque wrench to make
sure the fastener is secure.
When finished using the Impact Wrench,
9.
center the Forward/Reverse Lever (26).
10. To remove the Battery Pack (35), press
in on both buttons on the side of the
Battery Pack and slide the Impact
Wrench off of the Battery Pack.
11. Store the tool and Battery Pack (35)
in it's Storage Case (38), away from
children.
"breaking loose" Fasteners
To loosen a fastener which has become
"frozen", typically due to corrosion:
1. Spray silicon or another appropriate
lubricant (sold separately) on the
fastener and allow it to sit for 15-30
minutes.
2. Position the socket over the fastener,
then operate the Impact Wrench for short
intervals, first in one direction, then the
other direction to loosen the bolt. Be
sure to let the Impact Anvil (6) come to
a compete stop, before changing the
direction of rotation.
SKU 67845