Enabling Java Card Power-On Authentication And Creating An Administrator Java Card - HP Compaq NX6315 Getting Started Manual

Enabling Java Card power-on authentication and creating an administrator Java Card

To enable Java Card power-on authentication:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, click Java Card Security, and then click Advanced.
3. When the Computer Setup Password dialog box displays, enter your Computer Setup setup
password, and then click OK.
4. Insert the Java Card into the smart card reader.
NOTE
allowing you to enter a new PIN.
5. In the right pane, under Power-on authentication, select the Enable check box.
6. If you do not have DriveLock enabled, enter the Java Card PIN, and then click OK.
– or –
If you do have DriveLock enabled:
a. click Make Java card identity unique.
– or –
click Make the Java card identity the same as the DriveLock password.
b. If applicable, enter your DriveLock user password in the DriveLock password box, and then
enter it again in the Confirm password box.
c. Enter the Java Card PIN.
d. Click OK.
7. When you are prompted to create a recovery file, refer to
click Cancel and create a recovery file at a later time.
ENWW
If you have not assigned a PIN to this card, the Change PIN dialog box opens,
NOTE If DriveLock is enabled on the computer, you can set the Java Card identity
to be the same as the DriveLock user password, which allows you to validate both
DriveLock and the Java Card using only the Java Card when starting the computer.
"Creating a recovery
Advanced tasks (administrators only)
file," or you can
21