Setting And Changing The Smart Card User Password - HP Compaq NX6315 Getting Started Manual

Setting and changing the smart card user password

To set or change the smart card user password:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, click Smart Card Security, and then click BIOS.
3. In the right pane, under BIOS Security Mode, next to BIOS user card, click the Set button.
NOTE
4. Enter the smart card PIN and click Next.
5. Insert the new user card and click Next.
●
If there is already a user password on the card, the Finish dialog box is displayed. Omit steps
6 through 8 and go to step 9.
●
If there is no user password on the card, the BIOS Password Wizard opens.
6. In the BIOS Password Wizard, you can either
● Enter a password manually.
● Generate a random 32-byte password.
NOTE
recovery file. Generating a random password offers more security; however, you must have
a recovery file to make backup cards.
7. Under Boot Requirements, select the check box if you require the smart card PIN to be entered
at startup.
NOTE
box.
8. Enter the smart card PIN and click OK. The system prompts you to create a recovery file.
NOTE
to
9. Enter the smart card PIN in the Finish dialog box, and then click Finish.
ENWW
If there is already a user password in Computer Setup, click the Change button.
Using a known password enables you to create duplicate cards without using a
If you do not require the smart card PIN to be entered at startup, clear this check
It is highly recommended that you create a recovery file. For more information, refer
"Creating a recovery file," later in this chapter.
Smart card BIOS security mode 11