Computer Setup; Computer Setup Access - HP 500 Maintenance And Service Manual

6

Computer Setup

WARNING!
troubleshooting and repair procedures are detailed to allow only subassembly-/module-level
repair. Because of the complexity of the individual boards and subassemblies, do not attempt to
make repairs at the component level or modifications to any printed wiring board. Improper repairs
can create a safety hazard. Any indication of component replacement or printed wiring board
modification may void any warranty or exchange allowances.

Computer Setup access

Computer Setup is a preinstalled, ROM-based utility that can be used even when the operating system
is not working or will not load.
NOTE
your computer.
NOTE
navigate and make selections.
NOTE
legacy support is enabled.
The information and settings in Computer Setup are accessed from the File, Security, Diagnostics, and
System Configuration menus.
1. Open Computer Setup by turning on or restarting the computer, and then pressing
"F10 = ROM Based Setup" message is displayed in the lower-left corner of the screen.
In Computer Setup, the following shortcuts are available:
● To change the language, press f2.
● To view navigation information, press f1.
●
To close open dialog boxes and return to the main Computer Setup screen esc.
2. Select the Files, Security, Diagnostics, or System Configuration menu.
3. To exit Computer Setup, choose one of the following methods:
●
To exit Computer Setup without saving your preferences, use the arrow keys to select File >
Ignore Changes and Exit. Then follow the instructions on the screen.
●
To save your preferences and exit Computer Setup, use the arrow keys to select File > Save
Changes and Exit. Then follow the instructions on the screen.
62 Chapter 6 Computer Setup
Only authorized technicians trained by HP should repair this equipment. All
Some of the Computer Setup menu items listed in this section may not be supported by
Pointing devices are not supported in Computer Setup. You must use the keyboard to
An external keyboard connected by USB can be used with Computer Setup only if USB
f10 while the
ENWW