HP 500 Maintenance And Service Manual page 56

4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/Mini PCI card module compartment cover (see
c. Optical drive (see
d. Switch cover (see
e. Keyboard (see
f. Display assembly (see
g. Base enclosure (see
h. Fan assembly (see
Remove the heat sink:
1. Remove the four Phillips PM2.5×6.0 screws (1) that secure the heat sink to the system board.
2. Slide the heat sink (2) to the left until the right side of the heat sink clears the top cover.
NOTE
processor, it may be necessary to move the heat sink from side to side to detach the heat
sink from the processor.
ENWW
Battery on page
Hard drive on page
Optical drive on page
Switch cover on page
Keyboard on page
Display assembly on page
Base enclosure on page
Fan assembly on page
Due to the adhesive quality of the thermal paste located between the heat sink and
28).
29)
Memory module on page
35)
37)
39)
41)
46)
49)
Component replacement procedures
31)
51