Speaker - HP 500 Maintenance And Service Manual

Speaker

Description
Speaker
Before removing the speaker, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/Mini PCI card module compartment cover (see
c. Optical drive (see
d. Switch cover (see
e. Keyboard (see
f. Display assembly (see
g. Base enclosure (see
Remove the speaker:
1. Disconnect the speaker cable (1) from the system board.
2. Remove the Phillips PM2.0×9.0 screw (2) that secures the speaker to the top cover.
3. Remove the speaker (3).
Reverse this procedure to install the speaker.
ENWW
Battery on page 28).
Hard drive on page 29)
Optical drive on page
Switch cover on page
Keyboard on page 39)
Display assembly on page
Base enclosure on page
Spare part number
438559-001
Memory module on page
35)
37)
41)
46)
Component replacement procedures
31)
55