Setting Up Your Computers - Belkin F5D7631-4 User Manual

F5D7631-4_Manual
1. Connect the supplied power adapter to the Router power-input plug labeled
"Power".
Note: For safety and performance reasons, only use the supplied power
adapter to prevent damage to the Router.
2. After connecting the power adapter and the power source is turned on, the
Router's power icon
might take a few minutes for the Router to fully start up.
3. Turn on your computers. After your computers boot up, the LAN status LED
[Insert: LAN icon]
wired computer is connected. These lights show you the connection and
activity status. Now you are ready to configure the Router for ADSL
connection.
------------------------------------------------------------------------------------------------------------
---------------------

Setting Up your Computers

In order for your computer to properly communicate with your Router, you will
need to change your computer's "TCP/IP / Ethernet" settings to "Obtain an IP
address automatically / Using DHCP". This is normally the default setting in most
home computers.
You can set up the computer that is connected to the ADSL modem FIRST using
these steps. You can also use these steps to add computers to your Router after
the Router has been set up to connect to the Internet.
Manually Configuring Network Adapters in Windows XP, 2000, or NT
1. Click "Start", "Settings", then "Control Panel".
2. Double-click on the "Network and dial-up connections" icon (Windows 2000)
or the "Network" icon (Windows XP).
3. Right-click on the "Local Area Connection" associated with your network
adapter and select "Properties" from the drop-down menu.
4. In the "Local Area Connection Properties" window, click "Internet Protocol
(TCP/IP)" and click the "Properties" button. The following screen will appear:
(1)
Page 10 of 61
[Insert: Power icon]
on the front of the Router will be on for each port to which a
on the front panel should be on. It