Flash-To-Pass; Windshield Wipers - Chevrolet Malibu 2007 Malibu Owner's Manual

Flash-to-Pass

This feature lets you use your high-beam
headlamps momentarily to signal a driver in
front of you that you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps come
on, then release the lever to turn them off.

Windshield Wipers

Be sure to clear ice and snow from the wiper blades
before using them. If the wiper blades are frozen to
the windshield, gently loosen or thaw them. If the
blades do become damaged, install new blades
or blade inserts. See Windshield Wiper Blade
Replacement on page 395.
Heavy snow or ice can overload the wiper motor.
A circuit breaker will stop the motor until it cools
down. Clear away snow or ice to prevent an
overload. If the wipers gets stuck, turn the wipers
off, clear away the snow or ice, and then turn the
wipers back on.
Use this lever, located on the right side of the
steering wheel, to operate the windshield wipers.
(High Speed): Move the lever to this
1
position for steady wiping at high speed.
(Low Speed): Move the lever to this
6
position for steady wiping at low speed.
(Delay): Move the lever to this position to set
&
a delay between wipes.
173