Installation - Icom M-330GE Instruction Manual

■ MBF-5 installation
An optional MBF-5
flush mount kit
mounting the transceiver to a flat surface (less than 20 mm
thick), such as an instrument panel.
KEEP the transceiver and microphone at least 1 meter
away from your vessel's magnetic navigation compass.
1. Using the template on page 63, carefully cut a hole into
the instrument panel, or wherever you plan to mount
the transceiver. (Torque: 2 N•m)
2. Slide the transceiver through the hole, as shown below.
3. Attach the 2 bolts (5 × 8 mm) and spacer supplied with
the MBF-5 on both sides of the transceiver.
is available for
CONNECTIONS AND MAINTENANCE
4. Attach the clamps on both sides of the transceiver.
L Make sure that the clamps align parallel to the
transceiver body.
Clamp
5. Tighten the end bolts on the clamps (rotate clockwise)
so that the clamps press firmly against the inside of the
instrument control panel.
6. Tighten the locking nuts (rotate counterclockwise) so
that the transceiver is securely mounted in position, as
shown below. (Torque: 2 N•m)
7. Connect the antenna and power cable, then return the
instrument control panel to its original place.
Locking
nut
End bolt
9
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
57