Table of Contents
Advertisement
Cutter Replacement
When the cutter gets dull or if it gets damaged, it
must be replaced. Dull cutters can be resharpened
by a professional, but cutters are inexpensive and
easy to replace.
Tools Needed
Hex Wrench 4mm .............................................. 1
To replace the cutter:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove the guard.
3.
Loosen the two set screws that hold the cut-
ter in the spindle. (The set screws must be
backed out approximately half-way before
the cutter can be removed.)
4.
Slide the cutter out and insert the new one.
5.
Tighten the two set screws to secure the cut-
ter in place.
6.
Replace the guard.
NOTICE
The cutter must be readjusted after being
replaced to ensure proper cutting results.
-30-
Belt Tension
A flat belt transfers power from the motor to the
cutter spindle. This belt stretches with use and
periodically needs to be tensioned. If the cutter
lacks power, stops spinning, or cuts slower than
normal, then the belt may need to be tightened.
Qty
When properly tensioned, the belt should only
deflect approximately a
from the middle.
Tools Needed
Hex Wrench 6mm .............................................. 1
To tighten the belt:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the two motor mount cap screws
shown in Figure 52.
Figure 52. Motor mount cap screw locations.
⁄
" when pushed inward
1
4
Motor Mount Cap Screws
G0611X Dovetail Machine
Qty
Advertisement
Table of Contents
