Recommended Adjustments - Grizzly G7945 Owner's Manual

Note: Use 2" to 2
⁄ " long hex bolts.
1
4
7. Place the drill press on the base plate.
8. Position the drill press close to the front of the
mobile base, so the mobile base will not be a
tripping hazard.
9.
Mount the drill press to the base plate with
lag bolts and flat washers (Figure 18); or with
through bolts, flat washers, and hex nuts.
Figure 18. Drill press mounted on mobile base,
using a base plate for support.
-22-
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory; how-
ever, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments before operating
your machine—this will ensure that you know the
operating tolerances of your machine, and you
have them adjusted to your expectation.
Step-by-step instructions for these adjustments
can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1. Depth Stop Calibration (Page 35)
2. Feed Shaft Spring Tension (Page 35)
G7945/G7946 Radial Drill Press