Column And Base; Table Bracket - Grizzly G7945 Owner's Manual

Column and Base

Components and Hardware Needed:
Base ...................................................................1
Column ...............................................................1
Hex Bolts M10-1.5 x 40 (G7946) ........................4
Hex Bolts M8-1.25 x 20 (G7945) ........................4
The column must be secured on the base to
properly assemble your drill press.
To secure the column to the base:
1.
Place the column on the base and align the
mounting holes.
2.
Secure the column to the base with the four
hex bolts, as shown in Figure 7.
Figure 7. Column secured to base.
G7945/G7946 Radial Drill Press

Table Bracket

Qty
Components and Hardware Needed:
Table .................................................................. 1
Crank Handle .................................................... 1
Handle ............................................................... 1
Clamp Bolts (G7945) ......................................... 1
Clamp Bolts (G7946) ......................................... 3
Column .............................................................. 1
Column Support Arm (G7946) .......................... 1
Table Support Arm (G7946) .............................. 1
The table bracket must be installed as described
to properly assemble your drill press. The Model
G7945 comes with a one piece square table and
bracket. The Model G7946 comes with a round
table and two-piece hinged table bracket.
To install the table bracket:
1. Check to make sure the pinion gear is fully
inserted into the hole on the side of the table
bracket shown in Figure 8.
Table
Bracket
Figure 8. Pinion gear position.
2. Slide the crank handle over the pinion gear
shaft and align the set screw in the crank
handle with the flat portion of the shaft. Secure
with a 3mm hex wrench. See Figure 9.
3. Thread the handle into the crank handle.
4. Remove the column ring (Figure 10) by
loosening the set screw and remove the rack
(Figure 9). The end of the rack that has teeth
extending closest to the edge must be posi-
tioned down.
Qty
Pinion
Gear
-17-