Table of Contents
Advertisement
A = gear box
1.
Stand or prop each bed end B in an upright position on its legs.
2.
Using a mild soap/detergent and soft bristle brush or sponge,
scrub all exterior surfaces.
3.
Using a hose and nozzle attachment, rinse bed ends thoroughly
with plain cold or warm water.
Do not exceed a water temperature of 110° F.
Use household tap pressure. DO NOT use pressure
washers or steam cleaners.
4.
Tip bed end from side to side to allow any collected or trapped
water to drain.
5.
Thoroughly towel dry bed end and all components.
6.
Repeat drying process until all components are dry.
Ensure that the bed end is completely dry before storing.
1123842-I-05
All manuals and user guides at all-guides.com
6.4 Cleaning Head and Foot Sections
QUALIFIED TECHNICIAN ONLY
1.
2.
WARNING!
Risk Of Injury Or Damage
The electric motors, control box and pendant are NOT
protected against the entrance of dust and water.
– DO NOT spray water into any electrical components.
Unplug the power cord of electric beds before performing
maintenance.
Wipe down the bed with disinfectant. Allow it to dry completely.
Maintenance
35
Advertisement
Table of Contents
Troubleshooting
