Assemble And Install Adaptor - GE JVM3162RJSS Installation Instructions Manual

Over the range
Table of Contents

Advertisement

Available languages

Available languages

B4.
ADAPTING BLOWER FOR
OUTSIDE VENTILATION
(continued)
5
Place the blower unit back into the opening.
CAUTION
Do not pull or stretch the
blower unit wiring. Make sure the wires are
not pinched.
Replace blower motor screws removed in Step 2.
6
Slide cover plate into position on the back of the
unit. Replace blower plate and screws removed in
Step 1.
Blower Plate Screws
ASSEMBLE AND
B5.
INSTALL ADAPTOR
NOTE: On some models, the exhaust adaptor and
damper assembly may already be assembled to the
oven.
1
Place the oven in its upright position, with the top of
the unit facing up.
NOTE: Make sure the blower fan blades are
visible and are pointing up.
Insert the tabs on each side of the damper into the
2
holes at the inside rear of the adaptor.
18
Installation Instructions
Blower Plate
Back of
Oven
Blower Motor Screws
Cover Plate
Damper
Exhaust
Adaptor
Blower Plate
Back of
Oven
Cover Plate
Attach the exhaust adaptor to the blower plate
3
with the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure
proper alignment with your house exhaust duct
after the oven is installed.
B6.
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the microwave, thread
power cord through hole in bottom of top cabinet.
Keep it tight throughout Steps 1–3. Do not pinch
cord or lift microwave oven by pulling cord.
1
Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate.
Power Cord
Rotate front of microwave oven up against
2
cabinet bottom.
31-7000173 Rev. 0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jnm3163rj3ss

Table of Contents