Assemble And Install Adaptor; Mount The Microwave Oven - GE JVM3160DFCC Installation Instructions Manual

ASSEMBLE AND INSTALL ADAPTOR

B4
Damper
Blower
Plate
1
Place the microwave oven in its upright position, with
the top of the unit facing up and the front of the unit
facing toward you.
Remove the screw on the back side of the blower
2
plate and raise the blower plate off of the microwave.
Slide the damper from left to right into the tabs on the
3
blower plate. The yellow tape on the damper should
be facing away from you.
Remove the yellow tape from the damper.
4
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave oven is installed.
Position the blower plate with damper back on the
5
microwave and secure it with the screws that were
removed.
Installation Instructions
18
B5

MOUNT THE MICROWAVE OVEN

CAUTION:
IMPORTANT: Do not grip or use handle during
installation.
WARNING:
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
Lift microwave, tilt it forward, and hook slots at
1
back bottom edge onto four lower tabs of mounting
plate.
Power Cord
Rotate front of microwave oven up against cabinet
2
bottom.