GE JVM3162RJSS Installation Instructions Manual page 35

Over the range
Table of Contents

Advertisement

Available languages

Available languages

B5.
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
1 Remove the two screws that hold the blower
plate and remove the screw holding the blower
motor to the oven. Slide blower plate from under
its retaining flange.
Retaining
Flange
2
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
3 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
4
Roll the blower unit 90° so that fan blade
openings are facing out the back of the
oven.
Before Rolling
Back of
Oven
31-7000173 Rev. 0
Installation Instructions
Blower
Plate
Back of
Oven
After Rotation
Back of
Oven
After Rolling
Back of
Oven
Locate the two "knockout" plates, on the rear
5
oven panel, near the top of the oven.
Using tin snips, carefully cut the web area from
the two holes side-by-side (that secure the
knockouts to the oven). Cut all four webs on both
rear knockouts; this will allow the ventilation fan
airflow to exhaust out the rear of the oven.
CAUTION
Be sure to trim the sharp
edges from the openings after removing the
knockout plates.
Oven Rear Panel
6
Place the blower unit back into the opening.
AFTER: Fan
Blade Openings
Facing Back
CAUTION
Do not pull or stretch
the blower unit wiring. Make sure the
wires are not pinched.
NOTE: The blower unit exhaust openings
should match exhaust openings on rear of oven.
7
Replace the blower plate in the same
position as before and replace the screws for
the blower plate and blower motor.Attach the
cover on the blower plate with screw.
Blower
Plate
Screws
Snip all 4 webs
on each knockout
panel and remove
the metal
knockouts for rear
airflow.
Cover Plate
Blower Plate
Back of Oven
Blower Motor Screw
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jnm3163rj3ss

Table of Contents